Installation And Mounting - LODEL RA-600 Mode D'emploi

2

Installation and mounting

• This heater can be installed on feet (provided) or
on a wall.
• The heater must never be installed underneath a
mains wall socket.
• The heater must never be installed in a position
where the switches and other controls can be
reached by someone in the bath or shower.
• The heater works through natural air convection. In
order to achieve correct performance and uniform heat
distribution, when it is installed on a wall the lower
part of the heater must be at a minimum distance of
twenty centimetres from the floor and a minimum
distance of twenty centimetres from the sides and
fifty centimetres from an upper shelf and also a
minimum distance of twenty centimetres from any
wall or object (furniture and curtains etc).
IMPORTANT
Fig. 1
You can install your heater
in volume 3 in the bathroom.
It must not be possible to
reach it from the bath or
shower.
Fig. 2
28
4
2.1 WALL INSTALLATION:
1. Select a suitable location on the wall, which should
be firm and level. Check that there is a mains socket
close by.
2. The distances marked, "a" and "e" vary
depending on the heater model.
Safety distances and installation
Models a (mm)
LODEL4 410
LODEL6 550
LODEL8 690
LODEL10 830
S
3. Open the package box and check that all accessories
are present.
A
1 or 2 parts, according to
model
5 8 0
Distances
in mm
Fig. 3
b (mm) e (mm) f (mm)
93 140 495
93 280 495
93 420 495
93 560 495
Shelf
Distances in
mm
Object
Fig. 4
Object
B