Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Trimming with the precision trimming comb
With the precision trimming head with precision trimming comb, you can
trim hairs to a length of 4mm.
1
Put the precision trimming comb on the precision trimming head and
push it until it locks into place ('click').
2
Switch on the appliance. Turn the battery compartment cover from
the 'off' position (0) to the 'on' position (I).
3
Move the appliance slowly and with light pressure against the
direction of hair growth.
Note: To make trimming easier, stretch the skin with your free hand during
trimming.
Note: Make sure that the flat part of the comb always touches the skin to
obtain an even result.
Note: Do not press the appliance with the comb onto the skin too hard. This
may cause the appliance to trim the hairs shorter than the length indicated on
the comb.
Note: In areas where the hair grows in different directions, move the appliance
upwards, downwards and sideways.
4
Regularly remove cut hairs from the comb. If a lot of hairs have
accumulated in the comb, detach the comb from the appliance and
blow and/or shake the hairs out of it.
5
To switch off the appliance, turn the battery compartment to the 'off'
indication (0).
6
To detach the comb, put your finger under the bottom edge of the
comb and pull it off the appliance.
ENGLISH
7
Publicité
Table des Matières
