Rega P8 Mode D'emploi page 3

1
English
5 Français*
9 Deutsch*
13 Italiano*
17 Español*
21 Português*
25 Nederlands
29 Dansk*
33 Svenska*
37 Polski*
Thank you for purchasing this Rega product.
Please follow this quick set up guide to ensure optimum performance and perfect operation. Failure to do so may invalidate your
warranty. For more information on this product, please visit www.rega.co.uk.
Unpacking and positioning the Planar 8 turntable
•
•
•
•
•
•
•
1.
2.
3.
4.
5.
6.
7.
Always keep the turntable flat.
Follow the unpacking guide included in the box.
Save the packaging in case you need to transport your turntable in the future.
Place the turntable on a rigid, level surface. For the ultimate isolation solution, use the custom Rega wall bracket (sold
separately).
Ensure the drive belts are in place and remove the transport hub card from beneath the sub platter.
Carefully place the glass platter on the hub and fit the turntable mat.
When not in use, carefully position the lid over the centre spindle, and locate the dust cover anti rotation pin. Place into
location at the rear of the plinth (7)
1
Platter
Drive belt & sub platter (underneath the glass platter)
Tonearm
Balance weight
Skeletal plinth
Finger lift
Pin locator
7
2
4
3
5
6
1