Safety Measures - Super Ego Sego Drain 200 A Manuel D'instructions

Warning: This instructions manual must be read
thoroughly prior to pump installation and start
up. For safety reasons, persons who have not
read the instructions may not use the pump.
Persons under the age of 16 may not use the
pump and must keep away from pumps with the
power switched on.
The user is accountable to third parties for
everything related to pump operation (piping ins-
tallation, etc.).
Domestic power supply must be 16 A and be pro-
vided with a protection thermal-magnetic circuit
breaker Fl 30 mA.
The power supply must include a maximum cu-
rrent circuit breaker and an earth connection.
Check the power supply voltage.
Technical data on the nameplate must match the
power supply voltage.
If the pump is used for swimming pools, ponds,
water springs and related water installations,
compliance with current national regulations is
required.
Electrically driven pumps for use outdoors (Swim-
ming pools, ponds, etc.) must be provided with
rubber or Neoprene power cables type H07 RN-
F or H05_RNF according to DIN 57282 or DIN
57245.
No persons or pets may be present in the vicinity
of the pump operating area.
Pumped liquid temperature may not exceed 35º
C. If extension cables are used, rubber or Neopre-
ne cables type H07 RN-F or H05_RNF according
to DIN 57282 or DIN 7245 must always be used.

Safety Measures

Never lift, handle or pull from the pump using the
power cable
Make sure the power supply is kept away from
water and damp areas.
Prior to starting the pump, check for flawed or
worn out cables or power supply connections.
The power supply must be disconnected before
carrying out any work on the pump.
If the pump is installed in a sink / drain, the sink
must be covered after installation to protect pas-
sing-by pedestrians.
The discharge pipe must be positively fixed by
means of a hose clamp.
Do not exceed the maximum submergence (see
technical data)
In order that damages (room flooding, etc.) cau-
sed by a pump malfunction (anomaly or defect)
can be prevented, the owner (user) must take
adequate safety measures (install an alarm sys-
tem, stand –by pump or similar).
If the bottom is sandy or muddy, the pump must
be hanged from a rope or chain or placed onto
a proper base to prevent the suction area from
sinking into the bottom.
Damaged supply lines must be replaced by the
manufacturer or technical assistance service, or
else, by a qualified engineer.
Please note that in accordance with current re-
gulations involving damages caused by this type
of equipment, the manufacturer will not be held
liable for damages in the following cases:
- Pump repairs have been carried out in non au-
thorised shops;
- non-original spares have been used.
Same regulations apply for accessories.
9
GB