WAGNER WOOD&METAL EXTRA STANDARD Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects. The ventilation hose and diaphragm are only solvent-
resistant to a limited extent. Do not immerse in solvent, only wipe.
9) Pull the ventilating hose (Fig. 1 A, 12) at the top from the gun body. Screw off the valve
cover (13). Remove the diaphragm (14). Clean all the parts carefully.
10) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig. 1A, 14).
1) Place the diaphragm (Fig. 1A, 14) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 1A, 13) and screw it closed.
3) Place the ventilating hose (Fig. 1A, 12) on the valve cover and on the nipple at the
gun body.
4) Push the nozzle seal (Fig. 1B, 3) over the needle (2); the groove (slot) should point
towards you.
5) Put the nozzle (Fig. 1B, 4) onto the gun body and find the correct position by turning it.
6) Put the air cap (Fig. 1, 5) onto the nozzle (4) and tighten it using the union nut (6).
7) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.
Pos.
Designation
3
Nozzle seal
4
Nozzle (2.5 mm)
5
Air cap
Australia (AUS) version order no. in brackets
6
Union nut
9
Container seal
10
Feed tube
11
Container 800 ml with cover
Container (aluminium) 800 ml with cover
12,13,14 Ventilating hose, valve cover, diaphragm
15
O-ring
The CLICK&PAINT SYSTEM with additional spray attachments and accessories
offers the right tool for each work.
Further information about the WAGNER range of products for renovating is
available under www.wagner-group.com
8
Spare Parts List (Fig. 1)
Standard spray attachment
Order No.
0417 706
2362 878
2362 877
AUS (2361 747)
2362 873
2323 039
2362 876
0413 909
0420 708
2304 027
2362 875

Publicité

Table des Matières
loading

Table des Matières