Fellowes Powershred DS-1 Manuel D'utilisation Et D'instructions page 3

BASIC SHREDDING OPERATION
Continuous operation:
Up to 5-minute maximum
NOTE: Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 5-minutes will
trigger 20-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE TECHNOLOGY
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1 1
Press Auto-On ( )
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off
* Apply oil
across entry
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
PAPER JAM
1
2
Press and hold Alternate slowly back and forth
Reverse (R)
2-3 seconds
ATTENTION: If the SafeSense ® light remains on, you must engage the
Once the jam is cleared, reset the SafeSense
SafeSense paper jam: If the SafeSense
®
shredder has jammed when it has not, use the
paper. Warning – when switch is in override position, the SafeSense
function. Once the paper is cleared, reset the SafeSense
PAPER/CARD
1
Plug in and put
disconnect power switch
in ON (I) position
2
3
Touch test area Sensor lights up
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
3
Press and hold Reverse
(R) 2-3 seconds
3 4
Set to Off (O)
and unplug
Override Switch in order to perform steps above.
® feature. (See SafeSense ® instructions below.)
feature activates (SafeSense
®
Override Switch to deactivate the SafeSense
light will flash and the SafeSense
®
® feature.
3
2
Feed paper/card
Press Auto-On ( )
straight into paper
entry and release
TO CLEAN THE SENSORS
1
2
Turn off and unplug Locate Auto-start
shredder infrared sensor
5 6
Gently pull uncut
Press Auto-On
paper from paper
and resume shredding
entry. Plug in
light remains on) to cause the user to think the
®
® feature and clear the
feature will NOT
®
4
When finished shredding,
set to Off
.
4
3
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
Shredder doesn't start:
Yellow - SafeSense ® active
Yellow flashing - SafeSense
Make sure control switch is in Auto-On
( )
( ) position
Clear paper particles covering magnetic
safety interlock
Wait 20 minutes for red light to turn off
Sensor light illuminated–
paper jammed
SafeSense override switch
®
Active Not active
not active
®
3