Friedrich SS08 Manuel D'installation Et D'utilisation page 28

OPTIONAL: The factory assembles the supply cord so that it exits the left
side of the unit at the bottom. At the consumer's discretion,
h t s e p u l p c y r o c d n a
To do this, route the supply cord to the right side. Pull the
supply cord taunt through the loops (Refer to Cord Routing
Change, Figure 30) and route the cord down.
STEP 13. To attach and prevent damage to the front grille align the
cord notch over the cord and center the fresh air lever, then
align and tighten the four (4) captive screws as indicated by
the arrows in Figure 28. Before closing the front panel, be
sure the filter is in place. Make sure curtains do not block
the side air intakes.
STEP 14. Refer to the Control Panel Operation section for instructions.
STEP 15. You are now ready to control the comfort level of the room.
Figure 29
POWER CORD
CLIP
28
e b o r t u d e o t x e t t i e h i r h g i s t e d o t f
Use Tool Provided
e h n u . t i Please use the provided tool to attach the decorative front to the chassis.
Figure 28
B
LOCATION OF GRILLE
REMOVAL TOOL
CHASSIS SEAL
GASKET (ITEM 14)
USE HAND TOOLS
DO NOT OVER TIGHTEN
NOTE: WHEN INSTALLING THE CHASSIS
SEAL GASKET; BEGIN AT EITHER BOTTOM
CORNER AND GO UP THE SIDE & ACROSS
THE TOP & DOWN THE OPPOSITE SIDE.
FRR053
FRR024