Telcoma Automations PASSO Instructions Pour L'installation page 51

GB
PROGRAMMING – INTRODUCTION OF THE USER CODE
·
press and hold the key for approx. 2 seconds until the keypad be-
eps once.
·
introduce the MASTER code followed by , the LED
·
enter 01# to memorise codes for channel 1 of the receiver or
morise codes for channel 2 of the receiver, the LED
·
enter the code to be introduced followed by . The buzzer confirms
with a beep.
·
Proceed as above for any additional codes.
·
To exit the programming, press and hold the
emits a long beep followed by a double beep.
The keypad exits automatically from programming after a few seconds
of inactivity.
NOTE: - Each user code can only control one output relay.
- The user codes can be made up from 1 to 8 numbers.
- Codes of different lengths can be memorised on the same
system.
- A code cannot start with 0.
- The confirmation time of the codes introduced may increase
as the number of user codes memorised increases.
Example 1
I want to introduce the user code 12390 that will activate relay 1 of the
receiver
# 2233#
2 sec. MASTER code command
Example 2
I want to introduce the user codes 456 and 789 that will activate relay 2
of the receiver
# 2233#
2 sec. MASTER
code
#
01#
02# 456#
command new
USER (1)
# ☼
☼ starts to flash.
#
# key until the keypad
12390#
new USER
789#
new
USER (2) End
emains on.
02# to me-
#
2 sec. End of
programming
#
2 sec.
51