After Use - Weinmann JOYCE Mode D'emploi

This may also happen even if the correct
pressure is indicated on the therapy device.
Have your device combination adjusted by a
physician or distributor so that the pressure in
the mask corresponds to your therapy pressure.
Air humidifiers
®
JOYCE masks can be used with either cold-
air or warm-air humidifiers.
Never set the humidification level so high that
condensation forms in the air hose. Follow the
instructions for use of your humidifier and
therapy device.

3.7 After use

1.Unhook one of the lower headgear clips
from the mask and remove the mask.
2.Loosen the headgear clips and remove the
headgear from the mask.
3.Proceed as described in 4 "Cleaning and
disinfecting instructions".
3.8 Disassembling/reassembling the
mask
Disassembling the mask (Fig. D - A)
1.Detach the mask cushion from the mask
frame.
2.Remove the cap from the pressure
measurement ports.
3.Rotate the retaining ring counter-clockwise.
Now pull the retaining ring and the elbow
away from the mask frame.
4.Press the elbow through and out of the
retaining ring and pull the rotating sleeve
off the elbow.
5.Detach the coarse adjustment component
from the mask frame.
6.Detach the fine adjustment component from
the coarse adjustment component. Then
detach the forehead cushion from the fine
adjustment component.
12
Cleaning and disinfecting instructions
Reassembling the mask (Fig. A - D)
1.Attach the forehead cushion to the fine
adjustment component. Then attach the fine
adjustment component to the coarse
adjustment component.
2.Attach the coarse adjustment component to
the mask frame.
3.Push the rotating sleeve onto the elbow until
you hear it click into place.
4.Press the elbow into the retaining ring until
you hear it click into place.
5.Attach the retaining ring and elbow onto
the mask frame. Turn the retaining ring
clockwise until you hear it click into place.
6.Push the cap onto the pressure measurement
ports.
7.Attach the mask cushion to the mask frame.
8.Fasten the headgear to the mask with the
clips.
4 Cleaning and disinfecting
instructions
4.1 Schedule
Daily
Clean the mask in warm water to remove all
residues. You can disassemble the mask for
cleaning. Use a mild cleaning agent (e.g.
dishwasher detergent). After cleaning, rinse all
parts carefully with clean water.
Caution!
For patients with a weakened immune
system or a special medical history,
daily disinfection or sterilisation may be
necessary. In this case, please consult
your doctor.
Weekly
Disassemble the mask and clean and sterilise
the parts of the mask (see "Cleaning,
disinfection, sterilisation" on page 13).