Battery Status Indicator; Using The Appliance; Switching The Appliance On And Off - Philips OneBlade QP2630 Mode D'emploi

Masquer les pouces Voir aussi pour OneBlade QP2630:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Battery status indicator

- When the battery status indicator flashes
orange, the battery is almost empty (Fig. 4).
- When the appliance is charging, the battery
status indicator light flashes green.
- When the battery is fully charged, the battery
status indicator lights up green continuously
(Fig. 5).
Note: Approx. 30 minutes after the battery is
fully charged or when you disconnect the
appliance from the mains, the light of the
battery status indicator switches off
automatically.
Charging with the supply unit
1
Make sure the appliance is switched off.
2 Put the small plug into the appliance and put
the supply unit in the wall socket (Fig. 6).
The display of the appliance indicates that the
appliance is charging.
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.

Using the appliance

Your appliance comes with 2 blades. Use one
blade for your face only and the other blade
for your body.
The face blade and the stubble combs are for
use on facial hair. It is not intended for
shaving, edging or trimming hairs on lower
body parts or scalp hair.
The body blade and body comb are for use on
body parts below the neck.
The body blade with the skin guard attached
are for use on sensitive body areas.
Note: This appliance can only be used without
cord.
- Use the appliance with the face blade to trim,
edge or shave facial hair (beard, moustache and
sideburns). Shave for a smooth result, trim with
the stubble comb to obtain a certain length and
edge to create perfect edges and sharp lines.
- Use the appliance with the body blade to trim
and/or shave your body hair. Shave your chest
without the skin guard or body comb for a
smooth result, shave your sensitive areas (e.g.
groin, armpits) with the skin guard, use the body
comb to trim your body.
- Take your time when you first start to use the
appliance. You have to acquire practice with the
appliance.

Switching the appliance on and off

1
To switch on the appliance, press the on/off
button once (Fig. 7).
2 To switch off the appliance, press the on/off
button once.
Face
Shaving
Warning: Before you use the appliance, always
check the blade for damage or wear. If the
blade is damaged or worn, do not use the
appliance, as injury may occur. Replace a
damaged blade before you use the appliance
(see chapter 'Replacement').
Shaving tips and tricks
- Make sure that the blade is in full contact with
the skin by placing it flat on the skin.
- For the best result, move the appliance against
the grain.
- Make long strokes while pressing lightly.
- You can use the appliance dry or wet with gel or
foam. You can even use the appliance in the
shower.
- Shaving a clean beard and face gives the best
results.
Shaving
Before you use the appliance, always check
the blade for damage or wear. If the blade is
damaged or worn, do not use the appliance, as
injury may occur. Replace a damaged blade
before you use the appliance.
1
Switch on the appliance.
2 Place the blade on the skin and move the
appliance up or against the grain in long strokes
while you press it lightly (Fig. 8).
Note: Make sure you hold the surface of the
blade flat against your skin (Fig. 9).
3 Switch off and clean the appliance after every
use (see 'Cleaning and maintenance').
Edging
- You can also use both edges of the blade to
create sharp lines and perfect edges.
- Hold the appliance in such a way that the blade
is perpendicular to the skin and one of its edges
touches the skin. This allows more precise
detailing of sideburns and the area around the
mouth and nose.
1
Switch on the appliance.
2 Place the edge of the blade perpendicular onto
the skin (Fig. 11).
Note: To use the blade for creating sharp edges
and lines, use either edge of the blade (Fig. 10).
3 Make straight strokes while applying gentle
pressure (Fig. 12).
4 Switch off and clean the appliance after every
use (see 'Cleaning and maintenance').
Trimming with comb tips and tricks
The click-on stubble combs allow you to trim hair
to different lengths. This appliance comes with 4
click-on stubble combs: 5mm (3/16in.), 3mm
(1/8in.), 2mm (5/64in.) and 1mm (3/64in.). Start with
the 5mm comb to acquire practice with this
appliance. The indication on each comb
corresponds to the hair length in millimeters.
- Always make sure that the tips of the click-on
stubble comb point in the direction in which
you move the appliance.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Oneblade qp2630/30Oneblade qp2630/21

Table des Matières