Niko 101-78050 Mode D'emploi page 119

1XX-7805X
the Niko product range of sensors and actuators) are switched off
or are inactive.
Notes:
• The sensor can only be programmed with one- and two-
button modes.
• It is not recommended programming the sensor by
plugging it in and unplugging it briefly, because in that
case the telegrams for motion and light detection are sent
simultaneously. This leads to the programmed output(s)
being unnecessarily switched on and off.
• It is recommended that you use the following Nikobus
modes:
- For individual sensors:
switching module: M1 (on/off)
dimming module: M1 (on/off)
- For sensors connected in parallel:
switching module: M6 (switch-off delay)
dimming module: M7 (switch-off delay)
EN
1XX-7805X
118