Operation; General; Maintenance; Cleaning - Hatco GRS Manuel D'installation

General

Use the following procedure to turn on and operate the GRS,
GRSB, and GRSBF units.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
1. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. Refer to
the SPECIFICaTIONS section in this manual for details.
2. Move the Power On/Off (I/O) switch to the On (I) position.
BURN HAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
3. Turn the thermostat control to the desired temperature
setting.
Note: turning the thermostat control knob clockwise will
increase the temperature setting. turning the
thermostat control knob counterclockwise will decrease
the temperature setting.
4. allow the unit 30 minutes to reach operating temperature.
Note: Refer to the OPTIONS aND aCCESSORIES section
for installation and operation information for GRSB and
GRSBF units equipped with a flush-style remote
mounted control enclosure.
General
Hatco Glo-Ray Heated Shelf units are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Do not clean unit when it is energized or hot.
Use only Genuine Hatco Replacement Parts when service
is required. Failure to use Genuine Hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement
Parts are specified to operate safely in the environments in
which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that will
allow them to operate safely in Hatco equipment.
Form No. GRSCEM1-0515
CAUTION
Power On/Off
Switch
Control Panel — GRS Model
Thermostat
Control
Control Panel — GRSB and GRSBF Models
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
414-671-6350; fax 414-671-3976.

Cleaning

To preserve the finish of the Glo-Ray Heated Shelf, it is
recommended that all surfaces be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch the finish of the unit,
marring its appearance and making it susceptible to soil
accumulation.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove and wash all food pans, if necessary.
3. Wipe down all metal surfaces with a non-abrasive, damp
cloth. Stubborn stains may be removed with a good
stainless steel or non-abrasive cleaner. Clean hard to reach
areas using a small brush and mild soap.
4. Wipe dry all surfaces using a non-abrasive, dry cloth.
17

OPERATION

Thermostat
Control
POWER ON/OFF (I/O)
Switch

MAINTENANCE

WARNING
NOTICE