Urmet 1096/405 Guide Rapide page 8

EN
Installation
Make sure that no units are powered before starting the installation procedure.
POSITIONING AND CONNECTIONS
1. Loosen the locking ring on the bracket and the screw
2. Position the bracket on horizontal, vertical and transversal axes point the camera in
the desired direction.
In the case of mini-cameras, position the bracket in order to point the camera to the
direction useful to capture images; it is possible to adjust the camera on
HORIZONTAL, VERTICAL and TRANSVERSAL axes.
In the case of the minidome, rotate the body of the minidome for the chosen shot.
In the case of vandal dome, undo the dome support and turn the camera body for the chosen
shot, then close the dome again.
3. Once made, firmly block.
Important note: In order to avoid serious damages to the connection cable, avoid
rotating repeatedly and excessively the camera fixed to the bracket.
4. Connect the video output to the utility.
5. Power the camera.
VIDEO OUTPUT QUICK SELECTION
The camera has the possibility to use 4 different video outputs, to be selected through 2 dip
switches placed at the end of the connection table.
ON
1 2
ON
1 2
ON
1 2
ON
1 2
DS1096—114B
TVI video output
AHD video output
CVBS video output
CVI video output
8