IceTech SS Mode D'emploi page 5

CAUTION: ALL PACKING ELEMENTS (plastic bags, carton boxes and wood pallets) SHOULD BE KEPT
OUTSIDE THE REACH OF CHILDREN, AS THEY ARE A SOURCE OF POTENTIAL HAZARD.
INSTALLATION
THIS ICE MAKER IS NOT DESIGNED FOR OUTDOOR OPERATION.
An incorrect installation of the equipment may cause damages to individuals, animals or other
materials, being the manufacturer not responsible for such damages.
CAUTION:
The machines are designed to operate at room temperature between 5ºC (41ºF) and 43ºC (109.40ºF).
There may be some difficulties in ice- cube removal under the minimum temperatures. Above the maximum temperatu-
re, the life of the compressor is shortened and the production is substantially less.
The machines with air-cooler condenser take the air through the front section, and drive it off through the lateral and
back louvers.
Do not place anything over the maker or in facing the front louver.
In case the front louver is not enough, the exit is either total or partially obstructed or due to its placement it will receive
hot air from another device, we recommend, in case it is not possible to change the location of the machine, TO INSTALL
A WATER CONDENSER. IT IS IMPORTANT THAT THE WATER PIPING DO NOT PASS BY OR NEAR SOURCES OF HEAT SO AS
NOT TO LOSE ICE PRODUCTION.
THREAD THE SUPPORT LEGS TO THE BASE OF THE MACHINE ON THE HOUSING SET TO SUCH END AND
REGULATE THE HEIGHT AS TO HAVE THE EQUIPMENT PERFECTLY LEVELED.
Ventilation Louver
>4"
>10 cm
Jack
Base Jack
Bib
Water connection hose
Discharge hose
E N G L I S H
15 cm
3