Black & Decker SPACEMAKER TROS1000D Guide D'utilisation Et D'entretien page 8

6. Once holes are drilled, remove tape and mounting template.
7. Wipe dust and debris off the topside and underside of the cabinet
surface.
8. Place a washer inside the cabinet over each of the 4 holes you drilled.
9. Hold hood in place, aligning front of hood with front edge of
cabinet; drilled holes on cabinet should be aligned with mounting
holes on the hood.
10. Drop one of your screws through each of the washers covering the
holes in the cabinet, from inside the cabinet down.
Note: To determine which screws to use, you must have enough of the
screw exposed underneath the cabinet to properly thread the screw into
the nut.
11. Screwing from inside the cabinet down into holes, tighten 4 screws
in place to secure hood to cabinet.
Note: Always tighten screws to ensure the
appliance does not move or shake during
operation.
12. After the hood is secured, lift the toaster
oven up to mount. Hook the mounting tabs
on the front of the oven over the mounting
hooks at the front of the hood. (F).
Important: Do not put mounting hooks on
hood through the mounting tabs on the
oven. You must hook the tabs up and over
the hooks to properly hold.
13. Once the back hooks are secure, hook
your fingers around the feet on the back
of the toaster oven (G). Push back and up
on the feet at the same time to engage
the front hooks.
14. Plug into standard electrical outlet. Extra
cord can be hung over cord management
hook behind unit (H).
Warning: Risk of electrical shock and fire. Do
not allow cord to touch rear surface of oven.
Caution: This appliance features a Save-A-
Plug™ outlet receptacle to connect smaller
†SpaceMaker™ appliances such as the can
opener. Do not use this outlet for any other
appliance!
Note: If you are connecting another
†SpaceMaker™ appliance into the Save-A-Plug™
outlet, make sure you can easily unplug the
appliance after each use.
12. Your †SpaceMaker™ appliance is now ready for use!
F
G
H
8