Getting Started; Cho Ose A Loc Atio N - Black & Decker SPACEMAKER TROS1000D Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

G E T T ING STARTE D
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting parts and set them aside in a safe place where they will not roll
away or get lost.
Important: Do not attempt to operate appliance until it is properly
installed.

CHO OSE A LOC ATIO N

When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing location.
• DO NOT mount over any heating or cooking appliance such as your range or
oven.
Note: Do not install closer than 4 inches to any vertical surface or to any
horizontal surface beneath the unit.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light
fixtures.
Note: If you are mounting multiple †SpaceMaker™ appliances (A):
• Allow at least 4" between the side opposite the control panel
of your oven and the adjacent wall or the other appliance.
• Allow at least 1" between the control panel side of your oven
and the adjacent wall or the other appliance.
Caution: This appliance features a Save-A-Plug™ outlet receptacle to
connect smaller †SpaceMaker™ appliances such as the can opener.
DO NOT USE THIS OUTLET FOR ANY OTHER APPLIANCE!
Caution: When selecting a location for your toaster oven, make sure
you have adequate room to reach the Rear Receptacle.
Note: If you are connecting another †SpaceMaker™ appliance into the
Save-A-Plug™ outlet, make sure you can easily unplug the appliance
after each use.
6

Publicité

Table des Matières
loading

Table des Matières