Product Features; Technical Data; Noise/Vibration Information - BTI profiline WKS 230 E Notice Originale

Product Features

The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Spindle lock button
2 On/Off switch
3 Auxiliary handle
4 Grinder spindle
5 Protection guard for grinding
6 Encoding key
7 Clamping lever for protection guard
8 Screw for adjustment of protection guard
9 Protection guard for cutting*
10 Mounting flange with O-ring
11 Grinding/cutting disc*

Technical Data

Angle Grinder
Art. No.
Rated power input
Output power
Rated speed
Grinding disc diameter, max.
Thread of grinder spindle
Thread length (max.) of grinder spindle
Restarting Protection
Reduced starting current
Rotatable main handle
Run-on Brake
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these values
can vary.
Starting cycles generate brief voltage drops. Interference with other equipment/machines may occur in case of unfavourable
mains system conditions. Malfunctions are not to be expected for system impedances below 0.25 ohm.

Noise/Vibration Information

Measured values
EN 60745.
Typically the A-weighted noise levels of the product
are: Sound pressure level 91 dB(A); Sound power
level 102 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) determined
according to EN 60745:
Surface grinding:
2
a =8.5 m/s , Uncertainty K=1.5 m/s
h
Disk sanding: Vibration emission value a
Uncertainty K=1.5 m/s
1 609 929 U21 • 12.8.09
determined according
Vibration emission
2
,
=3.5 m/s
h
2
.
12 Clamping nut
13 Quick-clamping nut
14 Hand guard*
15 Spacer discs*
16 Rubber sanding plate*
17 Sanding sheet*
18 Round nut*
19 Cup brush*
20 Cutting guide with dust extraction protection
guard *
21 Diamond cutting disc*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
W
W
-1
min
mm
mm
kg
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is
used for different applications, with different accesso-
ries or poorly maintained, the vibration emission may
differ. This may significantly increase the exposure
level over the total working period.
An estimation of the level of exposure to vibration
value
should also take into account the times when the tool
2
is switched off or when it is running but not actually
,
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as: main-
tain the tool and the accessories, keep the hands
warm, organisation of work patterns.
*
WKS 230 SE
9027549
2400
1600
6500
230
M 14
18
6.6
/ II
WKS 230 E
9027547
2400
1600
6500
230
M 14
25
–
6.1
/ II
English | 41