Electromagnetic Fields (Emf); Flushing The Machine Before First Use - Philips Senseo HD6574 Mode D'emploi

- Do not use the SENSEO® machine in combination with water
softeners based on sodium exchange.
- Philips strongly advises you to descale this SENSEO® regularly. If
the machine is not descaled in time and according to the
procedure described in chapter 'Descaling', this may lead to
technical failures.
- Never interrupt the descaling process.
- Never use a descaling agent based on mineral acids such as
sulphuric acid, hydrochloric acid, sulphamic acid and acetic acid
(e.g. vinegar). These descaling agents may damage your coffee
machine.
- The machine is intended for normal household use only. It is not
intended for use in environments such as staff kitchens of shops,
offices, farms or other work environments. Nor is it intended to be
used by clients in hotels, motels, bed and breakfast and other
residential environments.

Electromagnetic fields (EMF)

This Philips machine complies with all applicable standards and regulations regarding exposure to
electromagnetic fields.
First use

Flushing the machine before first use

It is important that you flush the machine and milk spout before first use. After the flushing cycle
(which only takes approx. 2 minutes), the machine is ready for brewing SENSEO® coffee.
Caution: Never interrupt the flushing cycle halfway. If you do, the system does not fill itself
properly.
1 Tilt the top of the water reservoir backwards and lift the water reservoir off the machine (Fig. 2).
2 Fill the water reservoir to the MAX level with cold tap water (Fig. 3).
3 Tilt the water reservoir and place the bottom back onto the machine (1). Then press the top of the
water reservoir towards the machine (2) (Fig. 4).
4 Slide the milk spout into the machine over the guiding rails on the coffee spout. The milk spout is
attached properly when you hear a click (Fig. 5).
5 Place a bowl with a capacity of at least 1 liter under the spout (Fig. 6).
6 Make sure that a pod holder, without pod or pods, is in place (Fig. 7).
7 Put the plug in an earthed wall socket.
8 Press the on/off button. The button lights up to indicate that you have to flush the machine (Fig. 8).
9 To start flushing, press any of the recipe buttons on the touch panel (Fig. 9).
English
9