Hardware Setup - Velleman DVR4LCD Guide D'installation Rapide

DVR/PTZ
NUM KEYS
...
LCD adj.
Menu
No functionality
display mode
arrow keys
return
list
play
rewind
fast forward
stop
slow
snap
pause
No functionality
audio
zoom

6. Hardware setup

Installing the Hard Disk Drive (HDD)
Refer to the illustrations on page 3 of this manual.
• Obtain a suitable HDD (not included), type SATA (Serial Advanced Technology Attachment).
• Make sure to unplug the device from the mains before servicing and do not touch any electronic
circuitry to avoid electrostatic discharge.
• Place the device with the LCD facing down on a flat steady surface. Be careful not to damage the
LCD.
• [1] Lift the plastic cover at the interconnection between the screen and the stand and release the
4 screws (see arrows). Remove the whole stand.
• [2] Remove the blank plate by releasing the two screws (see arrows).
• [3] Place DVR module as indicated and release the 3 screws (see arrows). Open the top cover by
sliding it towards the back of the module.
• [4a&b] Locate the power supply cable [A] and data bus [B] and connect them to the applicable
connectors of a hard disk drive (not included).
• [5] Insert the HDD into the DVR module and secure it with at least 2 screws (see arrows).
• Slide the top cover back on the DVR module and secure it with the 3 screws (see [3]).
• [6] Gently slide the DVR module into the monitor as indicated ([C1] must be next to [B]). Do not
force. Secure with two screws (see arrows).
Connecting the video monitor
• Connect the VGA input of the monitor [B] with the VGA output of the DVR module [C1].
Connecting a camera
• Obtain up to four suitable cameras (not included). Each camera needs its own power supply.
• Connect the video output of the camera to either video input at the back of the DVR. The number
on the cable represents the channel number. Video channel 1 = V1, Video channel 2 = V2 ...
Connector type is BNC.
26/10/2009
DVR4LCD
not applicable
Select channel or enter DVR password.
Enter LCD menu to adjust the monitors' settings.
Note: this is also the only way to adjust the audio level.
Enter (or exit) the DVR set-up menu
Press to display video input in full screen mode. Press again to
scroll through the video inputs. Press
simultaneous display of the 4 input channels.
move through the menus and change selected settings
enter sub-menu or confirm setting
Display list of recorded files. Select from RECORD – MOTION –
ALARM – TIMER - FULL
press to play-back a recorded file
fast rewind the shown video
fast forward the shown video
stop play-back
play-back a recording at a slow speed
take a snapshot and save it to the USB device (not incl.)
press to pause the shown video
press to select the desired audio channel
Press to enlarge image. Not applicable when display mode is set
to "default".
No functionality (PTZ controls)
6
to return to
© Velleman nv