Velleman DVR4LCD Guide D'installation Rapide page 5

4. Features
• 19" true colour A grade LCD screen
• easy and modular installation design
• switchable between DVR and PC display via IR remote control
• H.264 video compression technology
highly improves video quality for live viewing and recording
o
recording file size is minimized for longest recording time
o
lower bit rate required for fastest network transfer
o
• multi-tasking: allows live display, recording, playback, and backup at the same time
• backup function: supports USB 2.0 flash drive backup and network backup
• intelligent motion trigger recording
advanced motion detection
o
scheduled motion detection recording (with 1 adjustable parameter)
o
quick search function
o
• A/V support: supports 4 audio inputs for sound recording (audio output through built-in speaker)
• multi-language OSD: English, French, Dutch, German, Italian, Portuguese, Spanish, Czech,
Hungarian and Greek
• full user manual: English
• supports SATA HDD
• supports daylight-saving function
• supports TCP/IP, PPPoE, DHCP and DDNS network connection
• supports manual / timer / motion / alarm / network recording functions
• system auto recovery after power reconnected
• hard disks in option: 500GB (HD500GB/S) or 750GB (HD750GB/S) (not included)
5. Overview
Refer to the illustrations on page 2 of this manual.
DVR4LCD
A AC POWER
B VGA input
C DVR MODULE
C1 VGA OUT
C2 LAN
C3 EXTERNAL I/O
C3a External alarm: connect up to 4 alarm inputs between terminal 1~4 and
ground. When an alarm is triggered, recording will start and a buzzer will
sound.
C3b audio inputs: connect up to 4 audio sources – the channel number is indicated
on the cable (A1 ... A4)
C3c video inputs: connect up to 4 video sources – the channel number is indicated
on the cable (V1 ... V4)
C3d RS485 connector
C4 VGA IN
C5 USB
D stand
Remote control
POWER
DVR/PC
26/10/2009
connect to a 230VAC/50Hz mains outlet
connect to the DVR module [C1]
contains the DVR functionality and storage HDD (not incl.)
connect this output to the VGA input [B]
connect to the network (RJ45)
connect the included DVR I/O cable with this port
1~4 alarm input (=channel 1 to 4)
G ground
0 alarm output
Connect to a PC (not incl.) to use the DVR4LCD as a standard PC
monitor. Use the remote control to switch between DVR and PC display.
for quick back-up or firmware upgrade, connect a compatible USB device
(FAT32 formatted, not incl.)
Press to power on the monitor.
Short press to go into power saving mode.
Long press to switch off the monitor. The system will prompt to
stop recording and confirm power-off.
Switch between DVR display and PC (when connected).
DVR4LCD
5
© Velleman nv