Replacing The Light Bulbs - abc home living 25685 Manuel D'instruction

B. Operation
On the first usage of remote controller, install the batteries first: open the battery box by sliding its cover
along the arrow, install two AAA batteries according to the marks in the box, and slide the cover to its
original position. If no batteries installed or the batteries are failure, the remote controller will be
unusable.
To use the remote controller effectively, point it to the electric fireplace and keep a distance of 1-5
meters. On the left side of the control display there is a <I/0> switch. To active the electrical heater it is
necessary to open the decoration grill cover and to switch this switch to the <I> position. If this switch is
on the <0> position, than the following functions are inactive.
There're four buttons marked the same as buttons on the remote controller, each pair of them perform
the same function, choose as you favour.
1. Power control. Press the <ON/OFF/ 0> switch, the electric fireplace will be powered on, and the
lamp will brighten up. The heater will not be turned on automatically when you power on the
fireplace, please refer to paragraph 3. Note, all operations are valid only when the power is on,
except to "turn the power on" operation. Press the <ON/OFF> switch again, the fireplace will be
powered off.
2. Adjust the brightness of simulated flame and logs. When the fireplace is powered on, flame is turned
on automatically, and it is as bright as when the fireplace is powered off. Press <DIMMER> button to
adjust the brightness, the
and keep changing. When the brightness goes to the point you want, press <DIMMER> button
again, and the brightness will keep still and the
3. Heater control. Lamp
is brighten up, in high-power status when
dark. When the heater is not in low-power status (
low-power status; when it's in low-power status (
off. Similarly, a <HIGH> button press will switch the heater to high-power status when
and turn it off when
heat, the hot air outlet may output air for 10 seconds. This is designed for protect circuit, and it's not
spoiled.
4. With the <I/0> switch you turn OFF the heater at the switch position <0>.
5. Power off the electric fireplace when you leave it for a long time.
Attention: Used up batteries belong not into the domestic refuse, but must be disposed in appropriate
collectors. Please ask your local administration for the responsible disposal place.
C. Replacing the light bulbs
If the flames fail to illuminate, it could be that the bulbs are defective. To replace this, you must first
disconnect the appliance from the mains and wait at least 10 minutes until the fireplace and the two
bulbs have cooled. The defective bulbs can be replaced only by the rear of the stove from. To do this,
unscrew the small metal cover off and take Carefully remove the defective filament bulb, screw them
carefully out of the bulb holder and replace them with new bulbs. Please only use candle bulbs with
max. 40 watts and E14 thread. Now unscrew the metal cover back on to the housing.
lamp will be flashing, and the brightness of the flame and logs will start
and indicates the status of heater. It's working in low-power status when
is brighten up. Note, before the heater emits heat or after it stop producing
GB3
lamp will keep brighten up.
is brighten up, turned off when both of
is dark), press <LOW> button will switch it to
is brighten up), press <LOW> button will turn it
and is
is dark,