Tours; Pattern - Lorex LNZ32P4 Série Manuel D'instructions

5 Controlling the PTZ Camera with an NVR

5.2.2 Tours

Tours will cycle through a set of presets.
To create a tour:
1. Click to open the PAN/TILT/ZOOM menu.
2. Click the Tour tab.
3. Under Patrol No., select the tour you would like to configure.
4. Under Preset, select a preset you would like to add to the tour.
5. Click Add Preset.
6. Repeat steps 4 and 5 to add additional presets to the tour.
NOTE
Click Del Tour to clear all presets from a tour.
7. Right-click to return to the advanced PTZ controls window.
To run a tour:
• Under No., select the number of the tour you would like to go to and click
NOTE
• There is a 5 second minimum pause between presets.
• Tour panning / tilting speed is slower than manual panning / tilting speed. The reduced speed maxi-
mizes reliability.
NOTE
The camera's full panning range is 355°. However, we recommend you do not make the camera pan
more than 270° between any two points in a tour.

5.2.3 Pattern

Patterns automatically cycle the camera between two positions.
To create a pattern:
1. Click to open the PAN/TILT/ZOOM menu.
#LX400075; r.34407/34407; en-US
.
16