Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
38" (965 mm) - 66" (1676 mm)
7. Install the Remote Control
Determine the desired location of the remote control docking station.
Position the docking station in the desired location and mark the location of the screw holes.
Remove the docking station.
Drill 1/4" holes at each of the screw locations.
Install anchors in each of the holes.
Remove the backing on the two-sided tape.
Attach the docking station to the wall using the two supplied screws.
Install the screw hole covers.
Install the batteries in the remote control (consult the Homeowners Guide for instructions if
needed).
Place the remote control on the docking station.
1221754-2-B
Docking Station
36"
(914 mm)
Remote Control
10
Anchor
Double-Sided Tape
Docking Station
Screw
Cover
Kohler Co.
Publicité
Table des Matières
