Klarstein JAM SESSION Mode D'emploi page 19

Assembly
• For better results, the appliance should stand straight and stable. Therefore place
the appliance base on a level surface, such as a countertop or sturdy table.
• Hold the pot by the handles. Place the pot on the base with the handles aligned
with sides of base, aligning the hole in the bottom of the pot (figure 1) with the metal
prongs in the center of the base (figure 2). Make certain that the pot is firmly seated
on the base before proceeding.
Figure 1
• Insert the stirrer in the pot with the blades towards the bottom (figure 3). The post
in the center of the stirrer should align with the hole in the bottom of the pot. Rotate
and press the stirrer until it reaches the bottom of the pot. It must be in the position
shown (figure 4).
Figure 3
Note: If the stirrer is not positioned correctly, it will not rotate properly and could
damage the pot. Make sure the stirrer reaches the bottom of the pot (as shown in
figure 4) before switching on the device.
Figure 2
Figure 4
EN
19