ALDEN Onelight 65 Guide D'installation page 37

How to glue the outside unit:
1. Mark the location of the external unit with a pencil. Now remove the external unit from the roof.
2. Sand the surface you must glue (roof, under the two fixation plates of the external unit) with
sandpaper (medium grain).
3. Clean each surface with a thinner.
4. Spread SikaAktivator -205 on the sanded surface.
Leave to dry for 15 to 20 minutes.
5. G lue generously the fixation plates of the external unit with
slightly on the unit. Layer of glue: ± 3 mm.
Leave to dry for 24 hours.
How to place and glue the waterproof cable box:
1. Position the waterproof cable box on the roof at the appropriate place and mark the location with a pencil.
Now remove the waterproof cable box.
2. In the center of this mark, drill a hole of the correct dimension, to enable the passage of the coax,
skew and motor cable without having to bend them. You must be able to cover the entire hole with the
waterproof cable box.
3. Smoothen the hole to avoid damaging the cables.
4. Thread the 2 cables through the hole (towards the inside of the vehicle) and place the waterproof cable
box on the roof making sure the cables are nor stuck nor bent. Increase the size of the hole if necessary.
5. Sand the surfaces that you have to glue (roof and under the waterproof cable box) with sandpaper
(medium grade).
6. Clean each surface with a Wax and Grease remover.
7. Spread SikaAktivator -205 on the sanded surfaces. Leave to dry for 15 to 20 minutes.
8. Glue generously the fastening parts of the waterproof cable box with Sikaflex
slightly on it. Layer of glue: ± 3 mm.
It is strictly forbidden to fill the entire waterproof cable box with glue !!!
Leave to dry for 24 hours.
ALD-10764
Sikaflex -512 Caravan
® then press
-512 Caravan then press
®
37