Inserting Oxygen Cylinders; Medumat Holder - Weinmann ULM CASE I Mode D'emploi

5.4 Inserting Oxygen Cylinders

Important!
Your hands must be free
of grease and products
containing alcohol when
you insert or change
oxygen cylinders. Fire
hazard!

5.5 MEDUMAT Holder

10 EN Operation
Be sure to wash your hands before you insert or change
oxygen cylinders.
If you want to fasten an oxygen cylinder of 0.8 liters or
2.0 liters into the case bottom
(9), use accessory WM 15141, Set of two belts for
oxygen cylinders (17). Fasten the oxygen cylinder in the
oxygen cylinder compartment (7) as shown in the illustra-
tion. To fasten a 2.0-liter oxygen cylinder, use the outer
clamp (6) on the floor of the case. If you want to fasten
an 0.8-liter cylinder, use the middle and left clamps. Be
sure that you pull the belts tightly during assembly in
order to prevent the cylinders from slipping out of place.
To fasten a MEDUMAT ventilation device into the case
bottom, use the holder for MEDUMAT (22). Click the ME-
DUMAT holder into place in the case bottom as shown
in the illustration. Then place the MEDUMAT so that the
lower grid on the device catches in the gap in the holder.
Press the MEDUMAT up into the holder until you hear it
click into place.