3M Demi-Masque réutilisable Mode D'emploi page 6

positioning the peg on the facepiece into the notch at
stems through until they are seated and secured.
NOTE: Conduct a negative pressure user seal
check to ensure exhalation valve is functioning
properly.
CLEANING AND DISINFECTION
Cleaning is recommended after each use.
respirator.
necessary
a solution of quaternary ammonia disinfectant or
sodium hypochlorite or other disinfectant. Rinse in
clean, warm water and air dry at room temperature in a
parts until facepiece is completely dry.
CAUTION
other oils on these products.
STORAGE AND TRANSPORTATION
product throughout the European Union. When stored
as stated, the expected shelf life of the product is 5
\ Temperature Range
]
@
: Name and address of Manufacturer
J
and the arrow will point to the month of manufacture in
their month and year of manufacture.
TECHNICAL SPECIFICATION
Respiratory Protection EN140 - for use with 3M
detailed in the Reference Leaflet.
When used with the following 3M equipment, this
up to:
P1 Particulate Filters
P2 Particulate Filters
P3 Particulate Filters
Filters
Filters
Filters
These products meet the requirements of the European
5
Maximum Use
Concentration
4 x WEL
10 x WEL
20 x WEL
10 x WEL or 1000 ppm
10 x WEL or 5000 ppm
Contact 3M for
additional information.