3M Demi-Masque réutilisable Mode D'emploi page 108

ASSEMBLY INSTRUCTIONS
leaflet)
FITTING INSTRUCTIONS
^ Before initial donning, if using 6500QL (Quick
latch) product, ensure that the quick latch is closed
and the upper straps are seated in the latch guides.
IMPORTANT NOTICE: After initial donning of the
6500QL Quick Latch Half Mask, once straps are
adjusted to proper length, subsequent donning can
be done with quick latch initially in open or closed
position. To don with the quick latch in the open
position, follow steps as above for fitting the head
harness, then raise mask to the in-use position
according to the procedure described in the "Using
Quick Latch Drop-Down Suspension" section of
these User Instructions.
These fitting instructions MUST be followed each
time respirator is worn.
FIT CHECK
approved configurations)
respirator on your face and/or readjust the tension of
reposition the respirator on your face and/or readjust
^ If you CANNOT achieve a proper fit DO NOT
enter the hazardous area.
Quantitative Fit Testing
For information regarding fit testing procedures, please
contact 3M.
USING QUICK LATCH DROP-DOWN
SUSPENSION
IMPORTANT NOTICE:
the crown of the head.
in-use position on the face to the drop-down position
on the face.
DOFFING
^ Do not remove the face piece, or filters until you
have vacated the contaminated area.
1. Release the tension on the head straps.
Replacement Parts Instructions
consist of identical parts, with the exception of the Head
Replacement
107