Automatic Shut-Off - Philips WardrobeCare GC9940/05 Mode D'emploi

4 Empty the water into the sink.
The rinse tray overflows if you do not empty it before the next Auto
Calc Clean session.
5 Slide the rinse tray back into the appliance.
The appliance stops beeping and the red light goes out.
,
6 The 'iron ready' light starts flashing to indicate that the appliance is
heating up.
After approximately 2 minutes, the 'iron ready' light stops flashing to
,
indicate that the appliance is ready for use again.

Automatic shut-off

- This appliance is equipped with an automatic shut-off function. When
the steam trigger is not used for more than 10 minutes, the appliance
automatically shuts off and goes into the standby mode. You hear a few
beeps and the light on the iron or steamer goes out.
1 To deactivate the automatic shut-off function, press the iron or
steamer power-on button once.
, The light on the iron or steamer flashes to indicate that the appliance
is heating up.
2 Wait for the light to stop flashing. When the light lights up
continuously, the appliance is ready for use again.
EnGlIsh
17