Waypoint - Waypoint (Saving Receiver's Position); Beeper - Indicating Standing Still - Dog trace DOG GPS X30 Mode D'emploi

8.5 WAYPOINT – saving receiver's position
The waypoint feature enables saving the GPS coordinates of the current receiver
(handset) location. Subsequently, you may navigate to the saved location.
Saving waypoint:
1. Hold the CODE push button on the receiver for 2 seconds.
2. Select position to which you wish to save the waypoint by
position is empty (at given position there is no paired transmitter, other receiver
or saved waypoint), the
3. Hold the MENU push button for 2 seconds to show
4. Press the
push button to return to the main screen.
To navigate to the saved waypoint, select in the main navigation panel by
arrows the saved location.
Deleting waypoint:
1. Switch off all transmitters (collars) in the receiver vicinity.
2. Hold the CODE push button on the receiver for 2 seconds.
3. Select position you wish to delete by
4. Hold the CODE push button for 2 seconds – after approximately 20 seconds
the
5. Press the
push button to return to the main screen.
WARNING: By saving the waypoint to a position where you have a paired
transmitter or other receiver, will delete the transmitter (receiver) from the
receiver's memory.
8.6 BEEPER feature – indicating standing still
The BEEPER feature is mainly used by gamekeepers/hunters to distinguish the
intensity of movement or the presence of a dog near wild pig.
If the transmitter (collar) is turned on and the dog is in motion, the BEEPER message
flashes in the main navigation window on the receiver display. If the dog does not
move or is near wild pig, the BEEPER is lit continuously. In the top line of the display,
the BEEPER indicates status when the sound or vibration indication is selected for at
least one dog on the receiver.
Setting the BEEPER feature:
The indicating standing still feature must be set correctly before hunting commences.
1. Long press the MENU push button, select
and holding the MENU push button.
2. Select the transmitter (collar) for which you wish to set BEEPER. Long press the
MENU push button.
3. Select the parameter you wish to set by using
pressing and holding the MENU push button.
4. Use the arrows
above, press .
5. When the BEEPER is fully set, return to the main screen by pressing repeatedly
message is displayed.
/ to select the required value or mode. To return to the level
message is shown on the display.
/ arrows.
and confirm by pressing
/
/ arrows. If the
.
arrows and confirm by
/
.
21