Setting The Sound Volume; Digital Compass Calibration - Dog trace DOG GPS X30 Mode D'emploi

1. Long press the MENU push button on the receiver you wish to track.
2. Select
3. Select and by repeatedly pressing
NOTE: Turning on transmission of the second receiver's position may be enabled
by the Dogtrace GPS app, which is linked to the second GPS receiver.
Now, you may start pairing this receiver with yours.
1. Turn on your receiver and the second receiver you wish to track – transmitters
(collars) in your vicinity must be turned off.
2. Hold the CODE push button on both receivers for 2 seconds.
3. On your receiver, select the position to which you wish to pair the second
transmitter (collar) using
there is no paired transmitter, receiver or saved waypoint), the
message is shown on the display.
4. Hold the CODE push button on your receiver again for 2 seconds.
5. Move both receivers close to each other with the RF aerials parallel to each other.
6. After pairing, the
on the display according to the selected position to which the receiver is paired.
7. To exit the coding mode press
NOTE: Another receiver paired to your receiver is indicated by the symbol
shown on the main LCD navigation panel.

7.7 Setting the sound volume

Receiver's sound volume may set to five levels.
1. Long press the MENU push button and select
2. Select sound volume level using
3. By repeatedly pressing
NOTE: Audio volume (loudness) may also be set by the Dogtrace GPS app.

7.8 Digital compass calibration

For viewing the exact direction to the transmitter collar, it is crucial that the calibration
is carried out correctly. If the device does not indicate the correct direction even with
the maximum GPS accuracy (two bars on both signal indicators on the display),
the calibration may not have been carried out for a long time or was carried out
incorrectly.
NOTE: Carry out calibration in an open area, away from objects that emit
magnetic field – buildings, cars, overhead and underground power lines.
arrows and long press MENU again.
by using /
/ arrows. If the position is empty (at given position
message is displayed and
on both receivers.
/ .
return to the main screen.
return to the main screen.
using
to is lit
/ arrows.
15