Channel Selection; Dog Gps X30 Feature; Tracking - Dog trace DOG GPS X30 Mode D'emploi

7.9 Channel selection

The number of active transmitters (collars) in the vicinity is restricted. In the event
that a large number of DOG GPS transmitters are transmitting at the same time, some
dog position messages send to your receiver may be lost. To increase the number of
active transmitters in one area, set the updating frequency to 9 seconds (Paragraph
6.4). Nevertheless, if the position messages are lost, this status will be indicated on
the DOG GPS X30 receiver by the
In this case, switch your transmitters (collars) and the receiver to another channel.
To change a channel, all transmitters (collars) must within close proximity – up to a
maximum of 10 meters.
NOTE: Channel switching is only possible for X30/X30T/X30B/X30TB receivers
and transmitters (collars). If any X20 or X20+ collars are paired on the receiver, the
receiver will not enable channel switching.
1. Turn on all transmitters and the receiver on which you wish to change channel.
2. Long press the MENU push button on the receiver.
3. Select
again.
4. Firstly, currently selected channel is displayed; to change press
reverse or .
5. Long press the MENU push button to confirm the selection. Each transmitter will
successively beep to indicate channel switching. One beep indicates switching to
the channel and two consecutive beeps to the channel .
6. If the channel is changed correctly
displays. If the change fails, the
Repeat the whole procedure from the step number 4.
7. By repeatedly pressing
8. Make sure that you receive RF signals from all your transmitters on your receiver.
If no, try switching the channel again to the desired receiver
WARNING: If other receivers (dog handlers) are paired with your receiver, you will
no longer be able to track them after changing the channel. These hunters would
also have to switch their receivers and transmitters to the same channel.
NOTE: Changing the transmitting channel may also be enabled by the Dogtrace
GPS app
8

8.1 Tracking

The transmitter (collar) and the receiver (handset) have built-in GPS receiver by
which both detect their position. The transmitter sends information about its positi-
on by means of the radio signal (RF) to the receiver, which shows the direction and
dog's distance from the handler on the display.
symbol next to the RF signal strength indication.
arrows and long press the MENU push button
using /
return to the receiver's main screen.
DOG GPS X30 FEATURES
message will show on all transmitters'
message will appear on the display.
/ and select
/ .
17