Important Safeguards - Russell Hobbs 12051-56 Mode D'emploi

Read the instructions and keep them safe. If you pass the appliance on, pass on the
instructions too. Remove all packaging, but keep it till you know the appliance works.

important safeguards

Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of a responsible adult.
2 Don't put the appliance in liquid, don't use it in a bathroom, near water, or
outdoors.
3 Store the appliance away from direct sunlight, and, if possible, from
fluorescent light.
4 Don't run the motor for more than 1 minute, or it may overheat. After 1 minute,
switch off for at least 3 minutes, to let the motor cool.
5 Don't use the appliance for any purpose other than those described in these
instructions.
6 Don't run the appliance empty, it may overheat.
7 Don't use the appliance if it's damaged or malfunctions.
dismantling
1 Turn the mill round so that you can see the rear.
2 Grip the cover in one hand, and the grinder in the other.
3 Turn the cover to move the pointer ) from L to U.
4 Lift the cover off.
fit batteries
1 Fit 4 R6/LR6 (AA) batteries into the motor unit.
2 The polarities (+ & -) are marked on the battery compartment.
fill the grinder
1 Lift the motor unit off the grinder.
2 Fill the grinder with peppercorns, sea salt, dried herbs or spices.
3 Don't overfill, or it won't fit together.
4 Align the pointers ) ) on the bottom of the motor unit with the padlocks L U on
the top of the grinder, and lower the motor unit on to the grinder.
5 The spindle should slide easily into the centre of the motor unit.
6 Lower the cover on to the motor unit.
7 Align the pointer ) on the cover with the open padlock U, push the cover down, then
turn it to align the pointer ) with the closed padlock L.
adjust the grind
1 Turn the whole mill upside down, and turn the knob right (-) till it won't go any
further.
2 Now turn it left (+) a little.
3 Turn the mill right way up, and press and release the switch.
4 Check the grind size, and adjust till it's the way you want it.
5 Don't turn it more than 6 complete turns towards +, or you may unscrew the knob
from the spindle.
6 Set the base down and sit the mill on the base.
7 Do the same for the other mill.
household use only
12