Assembling The Left Refrigerator Door - LG LFXS28596 Série Manuel Du Propriétaire

Assembling the Left Refrigerator
Door
Install the left refrigerator door after the right door is
installed.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator door
onto the middle hinge.
2
Fit the hinge (1) over the hinge lever latch and
slot it into place. Rotate the lever clockwise (2)
and fasten the hinge.
Hinge Lever Latch
3
Connect all the wire harnesses.
4
Push the water supply tube into the hole on the
top case and pull it through the backplate.
5
Hold the water supply connection and gently push
in the collet to connect the water supply line as
shown. Insert the tube at least 5/8 inch (15 mm)
into the connector. Insert the clip on the joint to
fasten the tube in place.
Collet
6
Place the cover (1) in place. Insert and tighten the
cover screw (2).
NOTE
Disassembling/Assembling the Water Lines
Collet
Tube
Insert line
(Correct)
Clip
• Gently press the collet and insert the tube until only
one line shows on the tube.
(Correct)
INSTALLATION 19
Collet
(Incorrect)