Table Des Matières; Quick Start Guide - Ebode TAKE 6 IR+RF Guide Utilisateur

User Guide
General Security Note
Attention: For carefree and safe use of this product, please read this manual
and safety information carefully and follow the instructions. Technical
manipulation of the product or any changes to the product are forbidden,
due to security and approval issues. Please take care to set up the device
correctly - consult your user guide. Children should use the device only
under adult supervision.
Important: the TAKE 6 must be used according the instructions in this manual
and is not suitable for other purposes.
Avoid the following
• strong mechanical wear and tear
• high temperature
• strong vibrations
• high humidity
Please also respect the additional security notes in the various user guide
chapters. To ensure correct set up please read the manual and security
notes carefully.
Battery install and change
The device may only be used with CR02032 batteries - never try to connect
to another power supply. When inserting batteries be sure the right polarity is
used. Remove the batteries when the device is not used for a longer period.
Make sure that the batteries are not short circuited and are not disposed in
fire (danger of explosion). Batteries do not belong in children hands. Don't
let batteries lay around openly - they might be swallowed by children or
animals. If this happens see a doctor immediately.
Disposal of batteries:
Batteries are special waste and do not belong in general household waste
disposal. Leaking or damaged batteries can upon contact with skin cause
burning or acid damage - if necessary use suitable gloves. Please dispose of
batteries in accordance with local bylaws.
Contents
Quick Start Guide
1. Introduction
2. Insert the batteries
3. Function of the remote's buttons
4. Programming
4.1. Manual code entry
4.2. Automatic code search for some well-known brands
4.3. Automatic code search for all brands
4.4. Manual code search
4.5 Learning codes
4.6. Identifying codes found
4.7 Volume Control Punch Through
4.8 X10 Home Automation Control
4.9 The FAV Key
5. Troubleshooting
6. Tips & Tricks about learning IR codes to a remote

Quick start guide

a) Put the batteries in
1. Open the cover on the back of the TAKE 6
2. Insert the two CR2032 batteries. Make sure the batteries are NEW.
16-10-2009 3 033000=15301