Ebode TAKE 6 IR+RF Guide Utilisateur page 11

If you want to control your lights and appliances you will also need, besides
the TAKE 6 Remote, a X10 compatible Home Automation Transceiver
Module. This can be plugged into any electrical socket. Use a Transceiver
Module (available separately) and connect your table lamp or other
electrical appliance. Switch on/off: control everything with the TAKE 6. The
Transceiver Module converts the RF signals of the TAKE 6 into an X10 signal
that is transferred via the mains power line. All other X10 modules that are
connected to your mains, are also operate able through the TAKE 6 Remote.
Contact your retailer for additional information.
4.9 The FAV key
The FAV key allows you to program two specific channels and switch
between them with a single key-press. The two channels can be up to 4
key-presses each and must be a minimum of 2. The first keypress must be a
Mode key e.g. TV with the following keys being up to 3 digits. To program
the FAV key :-
a. Press and hold the S (8) button until the LED remains on (occurring after
approximately 2-3 seconds).
b. Release S (8) button.
c. Press and release the FAV (10) key.
d. Press and release desired Mode (4) key (e.g. TV) followed by the 1, 2 or 3
digit keys in the correct order for the first channel selection. The LED will flash
for each keypress.
e. Press and release the FAV (10) key.
f. Repeat Step "d" for the second device channel selection.
g. Press and release the FAV (10) key to store the channel selections. The LED
will turn off and remote returns to normal.
To select between the two channels, press and release the FAV key.
5. Troubleshooting
The remote doesn't work or loses codes entered
• Confirm with your original remote that the equipment works correctly.
• Make sure that you have pressed the corresponding mode key of the
equipment or device that you want to control.
• If the listed code does not work, try the AUTOSEARCH method or enter the
next code of that brand.
• Check that the batteries have the correct polarity position.
• The programming of the remote requires 2 CR2032 batteries (new).
• If the LED is lit permanently, in general it will be necessary to replace the
batteries.
• Set the remote back to factory default.
How to set the TAKE 6 Remote back to factory default
• Press and hold S (8) until the LED indicator (2) lights steadily. Release S.
• Press and hold S (8) until the LED indicator (2) lights steadily. Release S.
• Press and release the 0 key (14) once.
• Press and release the S key (8).
• The LED (2) turns off after few seconds.
16-10-2009 11 033000=15301