Honeywell Miller WEBBING MOBILE LIFELINE KIT Mode D'emploi page 5

er or to a qualified repair centre for checking or destruction. After examination the centre will
or will not issue a written authorization for reusing the PPE.
It is strictly prohibited to modify or repair a piece of PPE yourself; only the manufacturer or a
repair centre are able to carry out these repairs.
In the case of a system supplied with built-in equipment, it is prohibited to replace any one of
the components of this system.
ANCHORAGE POINT
If possible, to be used with anchorage devices (conformed to the EN 795:2012 standard) or
structural anchor, that is to say elements fixed to a structure (wall, post...) For installation to a
concrete support, check that it is in good condition with no visible cracking.
Install the anchorage point so that:
• It offers minimum strength of 12 kN
• It is situated above the operator
• It is in the vertical axis to the work surface (less than 30°)
• It is totally suitable for the equipment anchorage device.
• It has no sharp edges.
• The fixed point of construction to which the strap ring is connected must have a shape
that prevents the disconnection and unintentional movement of the ring.
CARABINER
Connector conforming to standard EN 362.
When the karabiner is used for attachment to an anchorage points, check that the recom-
mendations of the "ANCHORAGE POINT" paragraph are complied with.
WHEN CONNECTING THE CARABINER, CHECK THAT THE LOCKING
ATTENTION:
The carabiner is an essential element as concerns your safety. Therefore we advise the fol-
lowing:
• assign the connector to one particular whenever possible,
• before each use, check in particular for any signs of the formation, signs of wear and that
the locking system operates properly.
• do not attach and release several times during the working day if it features a manual lock.
SIMILARLY IF THE KARABINER HAS BEEN USED TO ARREST A
FALL, FOR SAFETY REASONS, IT IS ESSENTIAL TO RETURN IT FOR
CLEARANCE
Before each use, make sure there is sufficient clearance under the user's feet to avoid colli-
sion with the structure or the ground.
PERIODIC EXAMINATION
These instructions must be kept with the product. Fill in the Individual protection equipment
identification sheet (see II) while entering information about marking.
This periodic examination is designed to check the efficiency and strength of the equipment
and is indispensable to protect the user.
This equipment must be examined at least once every year by a qualified person and in strict
compliance with the manufacturer's instructions; the check must be registered
Fig. 4
on the attached sheet and by placing a sticker on the product (see Fig. 4).
The frequency of the examination may need to be increased according to the
regulations, for intensive use or under harsh environmental conditions.
The product markings must be legible.
SYSTEM IS PROPERLY POSITIONED.
CHECKING.
5