Electrical Connection; Cleaning And Care; Eg- Declaration Of Conformity - Redwell WE250 Mode D'emploi

REDWELL

ELECTRICAL CONNECTION

The infrared heating element is provided with a mains plug. After having finished the assembly, connect to a 230 Volt, 50 Hz socket.
Room temperature controller can be included in the system by adapter plugs (socket thermostat) or in case of a fixed connection,
consult an installation specialist to install a control - taking into account the appropriate standards and norms of the country
concerned. If a stationary device is not equipped with a mains cable and a plug or another means of disconnecting the mains, which
has a contact opening width on each pin in accordance with the conditions of overvoltage category III for complete disconnection,
the instructions must mandate that a disconnection device of this type must be installed in the fixed electrical installation in
accordance with the installation regulations.

CLEANING AND CARE

Before cleaning, always disconnect the main power plug or switch without tension. Once a year before the heating season, free the
heating from dust and dirt and check the safety plates and the screws. If necessary, retighten them. To clean you should use a smooth
and damp cloth and some dish detergent. Never clean the infrared heating element and the power supply cables under running
water, nor submerse in water. Do not use harsh, abrasive or easily inflammable detergents.

EG- DECLARATION OF CONFORMITY

The Redwell Manufaktur GmbH declares that this device is in conform with the EMC regulation EMV 2014/30/EU and
with the Low-Voltage Directive 2014/35/EU.
DISPOSAL
The infrared heating element has to be disposed separately of general household waste at government places provided for this
purpose. You can obtain detailed information for disposal at the specialist dealer where the product was purchased.
designates that failure to comply with these guidelines can endanger your health and/or the function of your infrared
heating element.
designates, that the infrared heating element is conform to the European Directive 2012/19/EU.
The appropriate disposal and collection of scrap equipment serve to prevent potential environmental and health damages.
They are a requirement for the re-use and recycling of used electric and electronic devices.
designates further information and tips.
designates that the infrared heating element must not be covered.
10 - 10 - EN