DAITEM DP1612 Mode D'emploi page 8

GB
I For programming this example, carry out the following sequence:
Selecting programmable options
Choose one of functions described below, to be actived by the Prog
key .
The remote control is programmed for the Alert Call when you
take it out of its packaging.
Function
Alert call Triggers all means of alert (sirens, telephone dialer
interface,...)
Silent alarm Triggers telephone dialer interface only, without the sirens.
This use is particularly suited to the protection of the ill or
aged people
Audible signal Triggers an audible beep on the control panel
Light Activation of 230V command receiver
Stay arm Activation of Intrusion Gr 1 for attenuated control panel
reaction
Automation Control of a Daitem door
command
I For programming the key Prog., carry out the following sequence:
. . .
1. Start 2. Enter the
programming sequence
by pressing of 8 short key
both keys presses
simultaneously corresponding
until the indicator to the selected
light goes out function
If you make a mistake, the red indicator light will flash.
Repeat the procedure from the beginning.
14
Reaction of the system
3. Start 4. Press
programming the Prog. key.
by pressing The light then
both keys comes on again
simultaneously for 5 seconds to
until the indicator indicate successful
light goes out programming
Coding the Prog. key:
You can allocate one of the functions described below to the Prog.
key.
The symbol represents a press of the "Off" key.
The symbol represents a press of the "Total arm" key.
Function
Alert call
Silent alarm
Audible signal
Light
Stay arm
Gate "0"
Gate "1"
I Example, for programming the key
carry out the following sequence:
I Carry out a test with the control panel by pressing the
"Reprogrammable" key (in the case of Alert call, Silent alarm and
Audible signal or Stay Arm only).
I Press the Prog. key and check that the system responds accor-
ding to the programmed function.
Key "Prog." of the remote control
Alert call
Silent alert
Audible signal
Stay arm
You have transferred a specific code to the Prog. key on the remo-
te control.
❑ Note the chosen options on the memory aid at the end of the
use guide.
.
Coding the Prog. key
on the light function,
Voice message of the control panel
"Beep, Alert call"
"Beep, Silent alert"
"Beep beep beep beep"
"Beep, Stay arm"
GB
15