Preparing The Remote Control - DAITEM DP1612 Mode D'emploi

GB
Implementation
The remote control:
I DP1612 have 2 functions : Off and Complete.
I DP1614 have 4 functions : Off, Partial, Complete and Prog. key.
Light
indicator
On/
Group 2
Off
DP1612

Preparing the remote control

The batteries of the remote control are already fitted.
I Open the remote control by unscrewing the base.
I Remove the pre-cut section of the guarantee
sticker located inside hood and stick it on to the
guarantee extension request supplied.
I Verify the state of batteries by pressing a key, the
red LED should illuminate during the press.
12
Light
indicator
On/
Off
Group 2
Prog. key
Partial/Group 1
DP1614
Programming the personalized radio code
The installation radio code is coded by programming
I Use the personalised radio code selected for the control panel.
Key presses 1
Personalised radio code
Remote control code
On the "remote control code" line sketch beneath each cross the
symbol corresponding to the "Off" button.
I Complete the empty slots by sketching the
ponding to the Total Arm button.
You now have a series of
the programming code.
I Program the radio code by pressing the keys on the detector as
indicated below:
. . .
1. Start 2. Enter the
programming sequence
by pressing of 10 short key
both keys presses
simultaneously corresponding to
until the indicator the personalised
light goes out radio code
If you make a mistake, the red indicator light will flash.
Repeat the procedure from the beginning.
Ex. (not to be used): you have chosen the connections 2, 7 and 8.
Key presses 1
Personalised radio code
Remote control code
You now have a series of
entered on the remote control.
2 3 4 5 6 7 8
symbol corres-
and symbols corresponding to
3. Confirm the programming
by pressing both keys
simultaneously until the indicator
light goes out. The indicator light
will come on for 5 secondes
to indicate the programming
has been successful
2 3 4 5 6 7 8
x x x
and which is the code to be
GB
9 10
9 10
13