Motorola Solutions NNTN8234 Mode D'emploi page 11

Masquer les pouces Voir aussi pour NNTN8234:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
TROUBLESHOOTING
When troubleshooting, always observe the color of the LED:
(LED is for Rear Pocket ONLY. Charge indications for the
battery attached to a radio will be indicated via the radio
display)
Table 4: Rear Pocket Battery/Charger Status
LED Color
No LED indication
Single green blink
Blinking red
Steady red
Blinking orange
Battery/Charger Status
The Battery Pocket is empty.
Or, the Battery is not fully seated into the Charger
Battery Pocket or something is preventing the
Charger from detecting the Battery.
Successful charger power-up.
The Charger identified the Battery as invalid,
damaged or over-charged.
The Charger may have detected an open or
shorted Battery contact, corrupted Battery data, an
invalid Motorola identifier from the Battery memory
device, no Battery memory device.
The Charger successfully detected a Battery in the
Battery Pocket.
The Charger is charging the Battery.
The Battery is 0–90% charged.
The Charger successfully detected a Battery in the
Battery Pocket.
The Charger is Waiting to Charge the Battery.
Note: The wait may be because the Battery is too
hot, too cold, over-discharged, or
temporarily gave charge priority to the radio.
After the Battery temperature changes to an
acceptable value or the Charger recovers
the Battery from the over-discharged
condition, then the Charger will transition to
the appropriate charging mode.
9

Publicité

Table des Matières
loading

Table des Matières