Assembly - CAPITAL SPORTS Helix Star MR Mode D'emploi

ASSEMBLY

Assembly notes
• Please use floor padding, such as cardboard, to avoid scratching your
floor during assembly.
• The nuts and bolts have a little grease on them to protect them from
corrosion. Please keep a rag handy to wipe your hands.
• Some plastic end caps and plugs have been assembled on the unit prior
to shipment. They are shown on the assembly drawings for reference in
the event replacement parts are needed.
• The BIKE uses several different lengths of bolts. Be carefully to use the
correct length of bolt called for at each step of assembly.
Before you start assembling
Locate a comfortable work site. Assemble your cross trainer in an open space
with adequate ventilation and lighting. Because the cross trainer is portable
to some extent, you need not assemble it exactly where it is to be used. For
your convenience, however, you should avoid hauling the cross trainer across
excessive distance, through narrow passageways or over staircases once its
assembly is complete. If the cross trainer is to be assembled in living quarters,
protect the floor or carpet with a large mat before removing parts from carton.
EN
47