URBANGLIDE EBIKE M1 Manuel D'utilisation page 7

Put the part you unscrewed previously on the handlebar (3), then screw it back in place using the 4 screws. When
.
tightening, make sure you are aligned with the mark on the handlebars
3
STEP 3: ASSEMBLY OF THE SADDLE
Loosen the clamp by pulling the handle. (4) Then insert your saddle at the desired height. Please note that there is a
mark on the stem indicating the minimum height at which you should insert the saddle. (5) If you do not follow these
instructions, you may damage your bike and endanger yourself. Then tighten the clamp firmly and check that your
saddle is stable. Make sure that the saddle is properly aligned with the frame of your bicycle.
5
4
7