Safety Of Others - Black & Decker BEBLV260 Mode D'emploi

ENGLISH
Do not pick up matter that may be
u
contaminated with flammable or
combustible liquids such as gasoline,
or use in areas where they might be
present.
Do not place any objects into the
u
openings. Never use if the openings
are blocked - keep free of hair, lint,
dust and anything that may reduce the
airflow.
Warning! Always use your product in the
manner outlined in this manual.
Your product is designed to be used in an
upright mode and if it is used in any other
way it may result in injury. Never run your
product whilst lying on it's side or upside
down.
The operator or user is responsible for
u
accidents or hazards occurring to other
people or their property.
Do not carry the appliance by the
u
cable.
Always direct the cable to the rear
u
away from the appliance.
Warning! If a cord becomes damaged
during use, disconnect the supply cord
from the mains supply immediately. Do
not touch the supply cord before discon-
necting the supply.
Do not use solvents or cleaning fluids
u
to clean your product. Use a blunt
scraper to remove grass and dirt.
Check the collection bag frequently for
u
wear or deterioration.
Replacement fans are available from a
u
BLACK+DECKER service agent. Use
on BLACK+DECKER recommended
spare parts and accessories.
8
(Original instructions)
Keep all nuts bolts and screws tight to
u
make sure that the appliance is in a
safe working condition.

Safety of others

This appliance can be used by children
u
aged from 8 years and above and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance.
Cleaning and user maintenance shall
not be made by children without
supervision.
Children should be supervised to
u
ensure that they do not play with the
appliance.
Electrical safety
This appliance is double
insulated; therefore no earth wire
is required. Always check that
the power supply corresponds to
the voltage on the rating plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised BLACK+DECKER
Service Centre in order to avoid a
hazard.
Electric safety can be further improved
u
by using a highsensitivity 30 mA
Residual Current Device (RCD).