Compliance With Standards; Frost-Free Storage; Warranty And Support - Philips SENSEO Switch HD7891 Mode D'emploi

- Always put the machine on a flat and stable
surface.
- Do not place the machine on a hotplate or
directly next to a hot oven, heater or similar
source of heat.
- Do not place the machine in a cabinet
when in use.
- Never let the machine operate unattended.
- Do not use the machine at altitudes higher
than 2200 meters above sea level.
- Do not use the machine at a temperature
below 0 °C. Water left in the machine may
freeze and cause damage.
- Never pour any other liquid than clean cold
water into the water reservoir.
- Never flush the machine or let it brew coffee
when the spout is not in place.
- Flush the coffee machine with fresh water
before you use it for the first time. This
causes the system to fill with water, which is
essential for the machine to work properly.
- Do not use the machine in combination with
water softeners based on sodium exchange.
- Descale your machine regularly. The machine
indicates when descaling is needed. Not
doing this will make your machine stop
working properly. In this case, repair is not
covered by your warranty.
- Never interrupt the descaling process.
- Never use a descaling agent based on
mineral acids such as sulphuric acid,
hydrochloric acid, sulphamic acid and acetic
acid (e.g. vinegar). These descaling agents
may damage your coffee machine.
- The machine is intended for normal
household use only. It is not intended for use
in environments such as staff kitchens of
shops, offices, farms or other work
environments, nor is it intended to be used
by clients in hotels, motels, bed and
breakfasts and other residential
environments.
- Do not disassemble the insulated jug.
- Never immerse the insulated jug in water or
any other liquid, as this could cause water to
enter between the walls of the jug.
- When the insulated jug is filled with coffee,
keep it in upright position to prevent leakage.
- The insulated jug is not dishwasher-proof.
- During brewing (until the light stops flashing),
the filter holder contains hot coffee.

Compliance with standards

This machine complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
The energy consumption of this machine in off mode is less than 0.5 Watt.
This means that this machine complies with European Directive 2009/125/
EC, which sets the ecological design requirements for energy-using
products.

Frost-free storage

If you already used the coffee machine and have therefore already flushed
it with water, you may only use and store it in a frost-free place to prevent it
from becoming damaged.
Ordering accessories
To buy accessories or spare parts, visit www.philips.com/parts-and-
accessories or go to your Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the international warranty
leaflet for contact details).

Warranty and support

If you need information or support, please visit www.philips.com/support
or read the international warranty leaflet.
Recycling
-
This symbol means that this product shall not be disposed of with
normal household waste (2012/19/EU) (Fig. 1).
-
Follow your country's rules for the separate collection of electrical and
electronic products. Correct disposal helps prevent negative
consequences for the environment and human health.
Troubleshooting
This chapter summarizes the most common problems you could encounter
with the machine. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Philips Consumer Care Center in your country.
Problem Possible cause
My coffee cup You tried to brew
overflows with cold coffee without
coffee flushing the machine
before first use.
The light in the The machine is
button I pressed heating up.
flashes slowly.
When you are brewing
drip-filter coffee, the
light flashes slowly
during brewing.
The light in the There is not enough
button I pressed water in the water
flashes quickly. reservoir.
The float in the water
reservoir is stuck.
The CALC light This light flashes when
flashes when the you need to descale
machine is heating the machine.
up or brewing
coffee.
I cannot close the Perhaps a used coffee
lid properly. pod is sticking to the
water distribution disk.
The coffee Perhaps the sieve in
machine produces the center of the pod
less pod coffee holder is clogged.
than before.
You may have double
pressed the 1-cup or
2-cup button.
The temperature The type of cup
of the coffee you use is unable
decreases quickly. to retain the coffee
temperature for a long
time.
Solution
Flush the machine before
first use. When the machine
has emptied a complete
water reservoir, you can start
to make a new coffee.
This is normal. If heating
up takes longer than two
minutes, contact the Philips
Consumer Care Center in
your country.
When the water is used
up and the brewing sound
has stopped, it takes 90
seconds before the light
stops flashing. This time is
necessary to allow all water
to pass through the filter.
Fill the water reservoir.
Empty the water reservoir
and shake it a few times
to release the float. Clean
the water reservoir with hot
water and some washing-up
liquid or in the dishwasher.
If this does not help, descale
the machine.
Follow the instructions
under CALC to perform the
descaling procedure.
If this is the case, remove the
used pod.
If the sieve is clogged, use a
washing-up brush to unclog
the sieve. If you cannot
unclog it properly with the
washing-up brush, put the
pod holder in the machine
and descale the machine
(see under CALC).
If you double press the
1-cup or 2-cup button within
3 seconds, the machine
brews one or two cups of
short strong coffee.
Use thin-walled cups. Thin-
walled cups absorb less heat
from the coffee than thick-
walled cups. This ensures
that your coffee stays hot
longer.