GNC BluRay S Manuel D'installation, D'utilisation Et De Maintenance page 16

ENG
Insert the steel cable attached to the ceiling, in the regulator cylinder. Pressing the upper part of the cylinder, the locking mechanism is released
and the cable can be positioned at the preferred height. The excess part of the cable must never be cut. It can be rolled up and hidden among
the heat sink fins.
NOTICE: WHEN YOU INSERT THE CABLE IN THE CYLINDER, THIS MUST BE KEPT UPRIGHT FOR NOT DAMAGE THE MECHANISM.
BLURAY S is now fully assembled.
Finally, we can insert the plug of the power cable into the wall socket.
We recommend mounting the lamp at a minimum distance of 15 cm from the water surface. The Powerlink unit together with the Powercontrol
display supplies the lamp with low voltage and constant current via a 230V mains cable and a safety socket. The Powerlink must be positioned in
such a way as to be protected from water splashes. It is recommended to install the Powerlink under the bathtub surface, in a vertical position,
with the connectors (IN DC and OUT) facing downwards. This improves the performance of the driver modules and their durability, as double air-
flow is guaranteed. The Powercontrol can be placed in the technical compartment or next to the tank protected from water splashes. Both can be
fixed to the wall or cabinet with two screws using the holes provided. It is also recommended not to place the units near a sump or any other de-
vice for the treatment of the water in the tank. The Powercontrol, the Powerlink and the power supply are not watertight devices. It is absolutely
not recommended to cover them or insert them in compartments that are too narrow (not ventilated).
7. DISPLAY MANAGEMENT POWERCONTROL