Programming; End Of Programming; Operation; Switching The Display During Operation - Kübler Codix 531 Mode D'emploi

5.4.7 Minimum value acquisition
The minimum value may be saved and consulted during
operation (see 6.1)
Selection in the menu
Minimum value acquisition on
Minimum value acquisition off

5.5 End of programming

When programming is finished, end the prorgamming rou-
tine as follows:
Selection in the menu
Programming restarts. The set values
can be checked and modified.
Programming is finished. The set va-
lues are used in operation.
5.4.7.1 Resetting the minimum value
This allows defining whether the minimum value can be
reset during operation or not. However, the minimum value
can only be reset if the minimum value display is the active
function (see 6.1). If the minimum value is reset, the current
measured value becomes the new minimum value.
Selection in the menu
The minimum value can be reset
using the red key
The minimum value cannot be reset

6. Operation

6.1 Switching the display during operation

press the right-hand/grey key to select among the following
functions:
–current measured value
–minimum value
–maximum value.
Press the key once to display the designation of the active
display function for 2 seconds. If, during this time, the right-
hand grey key is pressed a second time, the display swit-
ches to the following display function. This is confirmed by a
2-second display of the designation of the new function.
After these 2 seconds, the display shows, depending on the
selection, the maximum value, the minimum value or the
current measured value.
1. Current measured value, press once the right-hand/grey
key
for 2 s:
⇑
after 2 s:
2. Minimum value (when active), press once the
right-hand/grey key
for 2 s:
⇑
after 2 s:
3. Maximum value (when active), press once the
right-hand/grey key
for 2 s:
⇑
after 2 s:
4. Current measured value, press once the
right-hand/grey key
for 2 s:
⇑
after 2 s:
15