Your Product At A Glance; Unpacking; Assembly; Operation - Lux Tools SW-360 Mode D'emploi

Seilzug_389828_389829.book Seite 16 Dienstag, 12. April 2016 2:35 14
GB
• Do not use the product if the steel cable is dam-
aged, knotted or twisted.
• Do not bend the steel cable or lay it over edges.
• Never couple several cable pulls.
• Never use the product to lift loads.
• Keep as far away from dirt as possible.
Personal protective equipment
Always wear the following safety equipment:
Hand protection: Work gloves made of
leather
Preventing your clothing from being caught on
something:
• Wear only close-fitting clothing!
• Do not wear any jewellery!
• If you have long hair, wear a hair net!

Your product at a glance

► P. 2, item 1
1. Hook
2. Ratchet lever
3. Axle bolts
4. Base frame
5. Crank
6. Steel cable

Unpacking

Unpacking the product and checking for complete-
ness.
DANGER! Risk of injury! Do not use a
knife or sharp object to remove the adhe-
sive tape from the steel cable pulley!
The steel cable can be damaged.
Scope of delivery
• Cable pull unit
• Crank
• Small parts
• Instructions for use

Assembly

► P. 2, item 2
– Mount the crank (5) to the axle bolt (3) using the
nuts provided.
– Unwind the steel cable until the screw holes in
the base frame (4) are easily accessible
(► Winding/unwinding the cable without load –
p. 16).
– Fasten the base frame to a solid and stable sur-
face using at least 3 screws/nuts (M10, not in
scope of delivery).
Note: Make sure that the crank can still be
completely turned following assembly.
If necessary, place a stable wooden board
or a metal plate between base frame and
assembly surface. Use screws long enough
for fastening.
16

Operation

Check before use!
DANGER! Risk of injury! The product
must only be put into operation if no
defects are found. Ensure that any defec-
tive parts are replaced before the product is
used again.
DANGER! Risk of injury! Check all
mechanical components before use. Pay
particular attention to material changes
such as crack formations, deformations
and material fractures.
If any component is faulty, the cable pull
must not be used.
Check the safety devices and the safe condition of
the product:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
– Check that the safety devices are in faultless
condition.
Moving or tensioning loads
DANGER! Risk of injury! ► P. 4, item 6
The steel cable must be visually checked
for damage before each use. This damage
can appear as shown in the illustration.
Products with damaged steel cable can
cause serious injury.
NOTICE! Risk of product damage! The
steel cable must not be laid around objects.
Loads to be moved must not be hooked
directly onto the steel cable. The hook must
always be used to attach the load.
Winding/unwinding the cable without load
► P. 3, item 3
– Place the ratchet lever (2) in the centre position.
The cable reel now moves freely in both directions.
– Pull the steel cable (6) at the fixed hook (1) until
the hook can be attached to the load to be
moved.
– Wind back in excessive cable by turning the
crank (5) clockwise.
Winding up the cable under load (towing, loading)
NOTICE! Risk of product damage! The
steel cable must run evenly distributed on
the pulley. Winding on just one side can
cause the cable to jam and become dam-
aged.
► P. 3, item 4
– Hold the crank (5) firmly and push gently to
relieve the ratchet lever (2).
– Place the ratchet lever (2) at Position [B].