Technaxx TX-101 Manuel D'utilisation page 19

FAQs
Problems with sound
Clockwise rotate the power/volume knob to increase the volume.
Make sure the power cord of the device is connected to an appropriate
electrical outlet and make sure the wall socket is switched on.
When playing records, make sure you have selected the correct speed (33,
45 or 78 rpm).
When playing music from a USB device (or SD card), make sure the
memory device is properly inserted in the USB port (SD card slot).
Electrical safety and cord handling
Before installing this equipment, make sure your outlet voltage corresponds
to the voltage stated on the appliance rating label.
To prevent contact with high voltage components inside, do not attempt to
open the equipment.
When connecting the equipment, align the plug properly and insert it fully to
prevent electric shock.
Only use this equipment with the cord and plug supplied, and do not
overload the power outlet.
If the power cord is damaged, do not use the equipment. The cord must be
replaced by the manufacturer or similarly qualified personnel in order to avoid
a hazard.
Note:
We advise you to clean your records with an anti-static cloth to gain
maximum enjoyment from them and to make them last. We would also point
out that for the same reason your stylus should be replaced periodically
(approximately every 250 hours) Dust the stylus from time to time using a very
soft brush dipped in alcohol (brushing from back to front of the cartridge).
When transporting your LP player do not forget to: 1. Replace the protective
cap on the stylus. 2. Put the rest clip into the pick-up arm.
9