Need Help - Philips Power2Charge SCM7880 Mode D'emploi

SCM7880 17-09-2007
7 Troubleshooting
Problem
– Possible cause
• Solution
USB adapter does not charge connected device
– Voltage of device does not correspond with that of USB
adapter.
• Refer to the user manual that came with the device.
– Improper connection between device and USB adapter.
• Make sure that the USB cable is properly inserted into
the device and the USB adapter.
– Damaged USB cable or connector tip.
• Replace USB cable and/or connector tip.
– Wrong connector tip used.
• Check connector tip and replace if necessary.
– Battery power of USB adapter too low.
• Charge USB adapter.
– Non supplied USB cable / connector tip used.
• Replace with supplied USB cable/connector tip.
– Problems with electrical circuit of USB adapter.
• Take the USB adapter to your local distributor.
USB adapter power runs out quickly
– USB adapter not fully charged before using.
• Fully charge USB adapter before using.
USB adapter cannot be charged
– Improper connection between USB adapter and wall outlet.
• Check that power plug is properly inserted into the wall
outlet.
– Problems with the electrical circuit of the USB adapter.
• Take USB adapter to your local distributor.
Note:
If you are unable to solve a problem by following the
above hints, try resetting the USB adapter by pressing
RESET.The RESET button is recessed to prevent
accidental reset of the USB adapter. Use a paperclip to
gently press the RESET button.
5
13:32 Pagina 5
8 Maintenance
• Recharge the USB adapter every three months when it
is not being used for a long period of time.
• Use a soft, lint-free cloth to clean the USB adapter
exterior. Do not use harsh chemicals, cleaning solvents
or strong detergents.
• When any problems occur with the USB adapter or the
accessories, take the adapter and accessories to your
local distributor.
9

Need help?

Online help: www.philips.com/welcome
For interactive help and frequently asked questions.